7800N Configure PPTP Client Dial Out to a Remote Location
Posted by Billion UK FAE 07 on 09 September 2011 05:25 PM

7800N Configure Onboard PPTP Cleint Dial Out

First enable the PPTP first if it isn't enabled already. If it is enabled, then click on the PPTP Client left hand side column. Follow the instruction on the next picture.

Configure the PPTP Client dial out to a remote location. Make sure the remote WAN IP address on step 'e' is correct.


Now, save the new settings permanently.

By default the PPTP authentication type is set to MS-Chap v2. If you are using a Windows VPN client to dial make sure the PPTP settings are correct before attempt dial out to the 7800N's VPN server (see below).

Comments (0)